W10900067 Dryer Thermostat Kit replaces AP6036100, PS11769432

XPARTCO W10900067 Dryer Thermal Cut-Off Fuse & Thermostat Kit – Compatible with Whirlpool, Maytag & Kenmore Dryers

Product Description

Restore safe and reliable dryer heating with the XPARTCO W10900067 Dryer Thermal Cut-Off Fuse & Thermostat Kit. This cut-off terminal is a replacement Part for specific Kenmore, Maytag, Roper, Whirlpool dryer models. The kit contains a 309°F Thermal Cut-Off Fuse and a high limit thermostat. In electric dryers, it shuts off the heat if overheating occurs to prevent fire risk. The thermal fuse cuts power while the thermostat regulates the operating temperature. To install, first, unplug the dryer. Use a multimeter to test the old fuse for continuity at room temperature; it should read zero ohms.

XPARTCO is a trusted aftermarket brand offering appliance replacement parts built to OEM-equivalent specifications at a cost-effective price.

Replaces Part Numbers

W10900067, 4460718, N197, 197CM, 197, PD00046493, EAP11769432, AP6036100, PS11769432.

Compatibility

This replacement dryer thermal cut-off fuse and thermostat kit fits select Whirlpool, Maytag, Kenmore, Amana, Estate, Roper, and Crosley electric dryers.

Example compatible models include (but are not limited to):

• Whirlpool WED4800XQ, WED4815EW1

• Maytag MEDC215EW1

• Kenmore 110.6012010

Always verify your dryer’s model number before ordering.
Contact our support team if you’re unsure.

✅ Key Features

• 🔄 Aftermarket Replacement Kit – Matches OEM temperature and safety specifications

• 🌡️ Accurate Heat Protection – Helps regulate dryer temperature safely

• 🔥 Overheat Safety Cut-Off – Prevents damage caused by excessive heat

• 💰 Cost-Effective Repair – Reliable alternative to higher-priced OEM kits

• 🛡️ Fixes Common Issues – Resolves no heat, overheating, and thermal shutdowns

📐 Product Specification

• Part Number: W10900067

• Component Type: Dryer Thermal Cut-Off Fuse & Thermostat Kit

• Includes: Thermal cut-off fuse and high-limit thermostat

• Application: Heater housing / exhaust temperature control

• Material: Heat-resistant metal housings

• Mounting: Screw-mounted

• Quality Level: Aftermarket replacement (not OEM)

🛠️ Installation Notes

Tools Needed: Phillips screwdriver, nut driver

⚠️ Safety First: Always unplug the dryer before servicing to avoid electrical shock.

Basic Steps:

1. Disconnect dryer power.

2. Remove the rear access panel.

3. Locate the thermal cut-off and thermostat on the heater housing.

4. Disconnect wiring and remove old components.

5. Install the new XPARTCO W10900067 components in the same positions.

6. Reconnect wiring, reinstall panel, and restore power.

7. Run a test cycle to confirm proper heating.

⏱️ Time Required: 20–30 minutes